Draining the Tank
Relieve the air pressure in the system and open the drain valve on the bottom of the tank to drain.
WARNING! CONDENSATION WILL ACCUMULATE IN THE TANK. TO PREVENT
CORROSION OF THE TANK FROM THE INSIDE, THIS MOISTURE MUS
T
BE DRAINED AT THE
END OF EVERY WORKDAY. BE SURE TO WEAR PROTECTIVE EYEWEAR.
Note: In cold climates, drain the tank after each use to reduce problems with
freezing of water condensation.
Checking the Relief Valve
Pull the pressure relief valve daily to ensure that it is operating property and to clear the valve of any possible
obstructions.
Testing for Leaks
Check that all connections are tight. A small leak in any of the hoses or pipe connections will
substantially reduce the performance of your air compressor. If you suspect a leak, spray a small
amount of soapy water around the area of the suspected leak with a spray bottle. If bubbles appear,
repair or replace the faulty component. Do not over tighten any connections.
Storage
Before storing the compressor for a prolonged period, use an air blow gun to clean all dust and
debris from the STORAGE compressor. Disconnect the power cord and coil it up. Pull the pressure
relief valve to release all pressure from the tank. Drain all moisture from the tank. Cover the entire
unit to protect it from moisture and dust.
Service
Perform the following maintenance at the intervals indicated below:
•
Operate the pressure relief valve: Daily
•
Drain tank: Daily
Manual 58-7992 V 1.7 – 8 Gallon compressor
2005-7-1
9
12
