16
15
6.Assembly the protective guard (E).
Hang the hooks of the protective guard
(E) onto the holes in supports
Secure the protective guards (E) with fixing
brackets (GG) with 4pcs screw Screw 3/16”
(HH).
Hardware Used
6
E
HH
GG
GG
Fixing
Bracket
x 4
7
8
HH
Hardware Used
HH
x 18
Screw 3/16”
II
JJ
KK
H
8
.
Install the knob (II) to screw M4x8 (KK)
and large flat washer (JJ).
Put the pothook of front panel (H) to the
holes of bottom plate (N).
Hardware Used
x 1
I I
Knob
KK
x 1
x 1
Screw M4 X 8
HH
x 4
Screw 3/16”
JJ
Large flat washer
7. Assemble three side panels (G) to heater
using 18pcs screw 3/16”.
Attention:
Do not cover the front side where the control
knob is.
5
5. Carefully install the glass tube (C) by
lifting up and inserting through the center
hole in the top plate assy (B). Ensure the
black silicone ring (F) is attached to the
lower edge of the glass tube (C) as illustrated.
Slide the glass tube (C) through the hole
of the lower plate cover and onto the middle
plate (J). Check and ensure that the glass
tube (C) is positioned properly and is
completely covering the center hole of
the middle plate(J).
To aid in installation
place black silicone
ring on the middle
plate and then
install glass tube.
Ensure the rim of
the glass tube sits
firmly in the black
silicone ring.
WARNING! The black
silicone ring must be in place
prior to operating the heater.
BLACK SILICONE
RING
ATTENTION:
Please unscrew Igniton to put in battery.
Summary of Contents for JMC-OSPH-SS
Page 1: ......
