SECTION 3 - CHASSIS & SCISSOR ARMS
3-10
3121788
Table 3-3. Fault Codes (Eagle Battery Charger)
LED Indications
Fault
Solution
30% RED LED
BLINKING
NO BATTERY DETECTED
This indication occurs whenever the charger circuitry cannot detect a bat-
tery. The charger circuitry will not allow charge current to flow under this
condition. With the AC power supply cord unplugged, check the connection
to the batteries for proper polarity (black wire to negative). Also check for
corrosion free secure connections to the battery.
30 & 60% RED LEDS
BLINKING
FORMING STAGE TIMEOUT
SHUTDOWN
This indication occurs if the battery voltage has not risen above 1.75 volts
per cell within the first 3 hours of charging. This indicates that a possible
battery problem exists and that the charge cycle has been terminated at
this point.
30, 60 & 90% RED LEDS
BLINKING
OVERALL TIMER SHUTDOWN
This indication occurs if the charger has not completed the charge cycle
within the allowable factory set time period. This indicates that a possible
battery problem exists and that the charge cycle has been terminated at
this point.
30 & 90% RED LEDS
BLINKING
INTERNAL OVERTEMP SHUTDOWN
This indication occurs if the charger circuitry has detected operating
temperatures inside the charger enclosure that are above factory specified
levels. This could indicate that a possible charger problem exists and that
the charge cycle has been terminated.
30% RED & 100% GREEN LEDS
BLINKING
BULK STAGE SHUTDOWN
This indication occurs if the battery voltage does not rise properly during
the Bulk Stage. This indicates that a possible battery problem exists and
that the charge cycle has been terminated at this point.
30% RED & 100% GREEN LEDS
ALTERNATE BLINKING ON OFF
DELTAVIEW SIGNAL OR NO BATTERY
DETECTED
This will be the NORMAL indication when the charger is plugged into A/C
but not connected to a battery pack, allowing the Delta View signal to be
retrieved with a Delta View Reader. This can also be considered the NO BAT-
TERY DETECTED fault code.
NOTE:
Disconnecting and reconnecting the AC power supply cord will reset the charger.
Go to
Discount-Equipment.com
to
order your
parts
