• Select the inputs that will go to the Record VTR after the cut. Select by entering
machine / crosspoint numbers and destination bus on the edit controller.
• Monitor the edit off of the Record VTR.
• Set the input levels by playing the source VTRs and match levels with VTR outputs
or mixer input trims.
• Preview the edit. If necessary, adjust input levels on mixer, and trim edit points on
the edit controller.
• Perform the edit on the edit controller
• Play the edit using the edit controller, and check for audio level consistency from
scene to scene.
Procedures for Edit Controlled Dissolve
• Check that you have followed the procedures for preparing for a session, specifi-
cally, that all interconnections have been made and levels are set.
• Ensure that the edit controller is communicating with DAFV
2
.
• Set up a dissolve on the edit controller by marking Source VTR and Record VTR in
and out edit points. On the edit controller, program the mode of the audio edit, A1, A2,
or both. That is to say, set up the Record VTR to record on track 1, track 2, or both.
• Select the desired input sources by entering machine / crosspoint numbers and
destination bus on the edit controller.
• Select the inputs that will go to the Record VTR after the dissolve. Select by
entering machine / crosspoint numbers and destination bus on the edit controller.
• Monitor the edit off of the Record VTR.
• Set the input levels by playing the source VTRs and match levels with VTR outputs
or mixer input trims.
• Preview the edit.
• Perform the edit on the edit controller
• Play the edit using the edit controller, and check for audio level consistency from
scene to scene.
18
