Continued on Next Page
SB-F-SUPRCNSL2/8W7_INSTR_SKU#011249
SB-F-SUPRCNSL2/8W7_INSTR_SKU#011249
S T E P 2 1
Using the supplied hardware, secure one of the L-brackets to
the right side of the Stealthbox®. The longer side of the
L-bracket runs down to the Stealthbox® threaded insert.
S T E P 2 0
Flip the Stealthbox / storage console around. Make sure that
the woofer will not rub against storage console, when the
woofer is in motion.
Trim the storage console around the woofer, if necessary.
S T E P 1 9
Secure the top section with he removed factory screws from
STEP 6
.
S T E P 1 8
Place the top section of the storage console back onto the
bottom section, around the Stealthbox.
Page 4 • JL Audio, Inc 2007
S T E P 2 3
From inside the truck, place the supplied A-bracket to the
front mounting bar, that is located on the transmission
hump.
Grab a pair of factory bolts that were removed in
STEP 1
.
Thread in the pair of factory bolts through the A-bracket, into
the factory mounting bar. Only thread in about a 1/4 of the
bolt into the mounting bar.
S T E P 2 5
Place the supplied mounting plate behind the rear mounting
bar as shown in the picture. The mounting plate’s mounting
holes need to reflect what is seen in the picture.
S T E P 2 4
Make sure the ignition is shut off.
To the rear of the transmission hump there is a silver box. At
the rear left corner area, you will see a grounding terminal
that is bolted to the floor. Remove this bolt and terminal and
secure the terminal to the floor by using the left rear
mounting bolt of the silver box, as shown in the picture.
Keep the terminal’s mounting bolt for future step.
S T E P 2 2
Using the supplied hardware, secure one of the L-brackets to
the left side of the Stealthbox®. The longer side of the
L-bracket runs down to the Stealthbox® threaded insert.
