Continued on Next Page
SB-F-SUPRCNSL2/8W7_INSTR_SKU#011249
SB-F-SUPRCNSL2/8W7_INSTR_SKU#011249
S T E P 1 4
Use the right side wall as a cutting guide, when cutting
down the right side corner. This is to make sure the cutting
tool is only cutting the necessary area. You do not want to
cut into the outer wall.
S T E P 1 3
With an air saw or similar tool, cut out the marked section.
Use the left side wall as a cutting guide, when cutting down
the left side corner. This is to make sure the cutting tool is
only cutting the necessary area. You do not want to cut into
the outer wall.
S T E P 1 2
Mark the area shown in the picture.
S T E P 1 1
Remove the 12v plug from the inner area of the storage
console.
Page 3 • JL Audio, Inc 2007
S T E P 1 6
Flip the bottom section of the storage console, to expose
the bottom side.
Mark the area (dash lines) shown in the picture.
S T E P 1 8
Flip the storage console over.
Place the Stealthbox into the modified storage console.
S T E P 1 7
On both side of the storage console, measure 6-inches from
the back wall to the front and mark. Shown in the picture.
Measure 10-inches from the middle of the rear wall to the
front and mark. Shown in the picture.
Staring at the 6-inch mark on both side of the console,
mark an continues curve to the 10-inch mark. Shown in the
picture.
With a cut off wheel or similar tool, cut on the marked lines
from
STEPs 16-17
.
S T E P 1 5
Turn the storage console to expose the rear.
At the top right area, measure and mark 2-inches from top to
bottom. At the right side, measure and mark
2 1/2-inches from right to left.
Use a 3-inch hole saw or similar cutting tool, cut on the
marked circle.
6-inches
6-inches
10-inches
2-inches
2-inches
9 1/2-inches
3/4-inches
3/4-inches
2-inches
2-inches
2 1/2-inches
2 1/2-inches
3-inch
3-inch
diameter
diameter
