Have a helper support the enclosure during this step.
Use the supplied butt connectors to connect the red (+)
and black (-) speaker cable exiting the ETXv3 enclosure
to the speaker cable exiting the pipe. The green and white
wires will not be used in this application.
9
Align the two upper halves of the fixture around the pipe.
Hand-tighten four 1/4 - 20 x 1-1/4” machine screws with
1/4” lock washers into the fixture. DO NOT TIGHTEN
FULLY AT THIS POINT.
11
Slide the excess speaker cable and the butt connectors
into the opening in the pipe as you raise the enclosure to
flush the fixture to the pipe.
10
Remove one of the 1/4 - 20 x 1-1/4” machine screws
and 1/4” lock washers at a time. Apply Loctite® red
thread-locking compound (included), reinstall, and fully
tighten. Repeat the same process for the other three
screws.
(Continued on reverse.)
12
