Adjust the angle of the fixture until level, mark the
location for the speaker cable hole. Remove the fixture
assembly, and drill a 1/2” hole on the mark.
5
Remove the four 1/4 - 20 x 1-1/4” machine screws and
1/4” lock washers to separate the two upper halves of
the fixture. Pass the speaker cable exiting the enclosure
through the opening on the underside of the fixture.
7
For applications where the cable cannot be routed
through the pipe, the cable can be passed through one of
the openings on the side of the fixture.
6
Apply Loctite® red thread-locking compound
(included) to two 5/16” - 18 x 1-1/4” machine screws
(included), thread them into the base of the fixture, and
push down on the fixture to ensure no gap while fully
tightening.
8
