There are two speaker cable routing options. For
applications where the cable cannot be routed
through the pipe, the cable can be passed through
one of the openings on the side of the Lower Fixture.
For applications where the cable can be routed
through the pipe, the cable can be passed through
the opening in the bottom of the Lower Fixture.
Steps 2, 3, and 6 are only necessary for this option.
Determine the speaker mounting location. Slide a
1/4" Split Lock Washer over each of the four 1/4 - 20
x 1-1/4” Machine Screws, and hand tighten the
screws into the Lower Fixture to temporarily secure
the two fixture halves around the pipe.
Adjust the angle of the fixture to the desired position,
and mark the location for the cable hole. Remove the
fixture assembly, and drill a 5/16" or 3/8" hole on the
mark. If necessary, use a file or sandpaper to smooth
the edges to ensure no sharp edges.
Align the Lower Fixture to the enclosure. Install (2)
5/16" Split Lock Washers and (2) 5/16 - 18 x 1-1/4”
Machine Screws as pictured. Apply Loctite® Red
Thread-Locking Compound to each screw end,
them into the Lower Fixture, and fully tighten while
pressing down on the Lower Fixture to ensure no gap.
Have a helper support the enclosure during this
step.
Connect the 16 AWG red/stripe (+) and black/
stripe (-) speaker cable exiting the ETXv3 enclosure
to the speaker cable exiting the pipe. For LED
models, connect the 20 AWG blue LED (+) and
yellow LED (-) as illustrated on Page 2.
1A
1B
OR
2
3
4
5
Installation Procedure:
thread
