JKEXER AeroWork 897, Owner'S Manual

Page: 12 / 26

REMARKS:
HRC 1 (SPEED ADJUSTMENT) OPERATION
1. Wearing a transmitter or holding two hands on the pulse plates, in 30 seconds after pressing
START button, computer will detect user's pulse and show it on the computer for further
operation.
2. If computer could not detect user's pulse in 30 seconds, machine will stop and figure on the
Pulse display will flash 3 times. 3 minutes after, machine will be resumed to standby mode.
3. If user's actual heartbeat is higher than preset max. heart beat, speed will decrease 0.2 kph per
detection. When speed reaches to the lowest but actual heartbeat is still higher than preset
max. heart beat, suggest you stop running and consult your physician.
4. If actual heartbeat is 20 times continuously higher than preset max. heart beat for 20 seconds,
system will stop, 3 minutes after, machine will be resumed to standby mode.
5. If actual heartbeat is lower than preset max. heartbeat, speed will increase 0.2 kph per
detection. When speed reaches to the highest but actual heartbeat is still lower than preset
max. heart beat, machine will keep running at the highest speed.
HRC 2 (INCLINE ADJUSTMENT) OPERATION
Operation is same as HRC 1 but increase or decrease 1% incline per detection.
HRC 3 (SPEED AND INCLINE ADJUSTMENT) OPERATION
Operation is same as HRC 1
1. Actual heart beat is lower than preset max. heart beat:
Firstly, speed will increase 0.2 kph per detection. After it reaches the highest speed, incline 1%
will increase per detection.
2. Actual heart beat is higher than preset max. heart beat:
Firstly, speed will decrease 0.2 kph per detection. After it reaches the lowest speed, incline 1%
will decrease per detection.
MAXIMUM HEARTBEAT SETTING (Default setting: 30 years old)
Level 1: (220 – age) x 60%
Level 2: (220 – age) x 75%
Level 3: (220 – age) x 85%
For User Program (U1, U2)
1st. Press SPEED or INCLINE / to choose User program U1 or U2.
2nd. Press and hold button until you hear a "bi" sound and 0 appears on incline window, 0.8
appears on speed window, and first dot flashes on both Dot Matrix.
3rd. Press INCLINE / and SPEED / to set desired incline and speed on first range.
4th. Press to confirm and second dots flashes on both Dot Matrix.
5th. Repeat above procedures to set from 2nd range to 12th range.
10