Rev. C
- 9
-
2.3.1 Fixation with screws
The frame of each module has 8 mounting holes (Length* Width: 14mm*9mm) used
to secure the modules to support structure. You can use the four symmetry holes
close to the inner side on module frame. If excessive wind or snow load are expected,
you must use all the eight mounting holes. The module frame must be attached to a
mounting rail using M8 corrosion-proof screws together with spring washers and flat
washers in eight symmetrical locations on the PV module. The applied torque value
should be big enough to fix the modules steadily. The reference value for M8 screw is
16~20N*m. As to special support system or special installation requirement, please
reconfirm with the support’s supplier for the torque value. Please find detailed
mounting information in the below illustration.
Figure 2 above: PV module installed with Screw fitting method*
Summary of Contents for JKM200M-60
Page 1: ...JinkoSolar Photovoltaic Module User Manual UL1703 ...
Page 26: ... 24 Note ...
