17/24
Setting the beeping steps
5.1.3 [Nominal value] input
The absolute and relative values must be entered in a nominal value. Direct reading value
comparison method The nominal value does not participate in the calculation, but in the [standard
[Setup] Setting display
Nominal] In the range mode, the nominal value of the resistance will participate in the range
selection.
Method, you need to enter the correct nominal value of the resistor.
Enter the nominal value:
Step 1
Select the [Measurement Settings] function key in the upper bar to
switch to the <Measurement Settings> page
Step 2
Use the cursor keys to select the [Nominal resistance] or [Nominal
voltage] field;
Step 3
Use the numeric keys to enter data, and the unit to select using the
function keys.
5.1.4 [Lower Limit] and [Upper Limit] settings
Step 1
Select the [Measurement Settings] function key in the upper bar to
switch to the <Measurement Settings> page
Step 2
Use the cursor keys to select the [Lower Resistance] or [Lower
Voltage] field;
Step 3
enter data using the numeric keypad
Step 4
Use the cursor keys to select [Resistance Upper Limit] and
[Resistance Lower Limit]
Step 5
enter data using the numeric keypad
Step 6
Repeat 2 ~ 5 to complete the data input of other files.
Enter data using the numeric keypad, then select the unit to complete the operation.
Note: The instrument shares the same storage space for the three comparison modes, so the
comparator data needs to be reset after switching the comparison mode
6. System settings
Close
Off beep
Pass
The buzzer sounds when the sorting
result is pass (GD)
Failed
The buzzer sounds when the sorting
result is disqualified (NG