jGun
2
JETYD Operations Manual
Air Supply Requirements
The air supply line must be ½-inch minimum diameter to allow adequate air flow
to the jGun.
The air supply must provide a minimum of 90 psi at 30 cfm.
Ensure that air line fittings are tight and leak free. Do not over tighten air line
fittings.
Always
use the Filter Regulator Lubricator (FRL) Unit provided
with the jGun.
Never use a substitute oiler and regulator.
Set the air pressure at the FRL
while the tool is running
as described in
FRL Setup and Use
.
Open the air supply connected to the FRL unit and run the jGun while setting
the pressure on the regulator gauge.
Set the air pressure to the PSI needed to achieve desired torque shown on the
provided pressure/torque conversion chart, also shown in
Pressure / Torque
Conversion Charts
.
Reaction Arm or Washer
Choose the correct reaction arm for the job. The jGun is shipped with a standard
length reaction arm, but your gun may have been ordered with a custom reaction
arm for a specific purpose.
