jGun
14
JETYD Operations Manual
Loosening a Fastener
1.
Set the FRL Pressure to max PSI as listed on Pressure/Torque Conversion Chart.
2.
Fully engage the torque wrench socket on the nut.
3.
Either place the reaction arm firmly against a stationary surface or engage the LoaDisc
Driver over the reaction washer.
Figure 11. Using the jGun with a Reaction Washer
4.
Ensure the torque wrench is set to the loosening direction.
5.
Remove the fastener.
jGun Repair and Maintenance
Although the FRL Unit keeps the jGun self-maintained by continuously provided pneumatic tool
oil to the tool during operation, proper repair and preventative maintenance will ensure the full
life span of your tool.
Maintaining Hoses and Fittings
Visually inspect air lines and air line fittings before tool use
Replace worn or leaking air lines
Tighten leaky fittings
