jGun
JETYD Operations Manual
19
Shifting Between Modes
The dual speed gun has two settings: High Speed and Maximum Torque
Figure 14. Maximum Torque Setting (Left) and Maximum Speed Setting (Right)
Maximum Torque Setting
This mode is activated when the tool is in its initial position (Figure 14 – left
photo), where the shifter is back against the body of the gun.
Operation during the maximum torque mode is similar to that of the single
speed jGun. The torque is applied until the bolts reach the desired load for any
specific application.
High Speed Setting
Shifting into high speed requires pushing the handle forward as shown (Figure
14 – right photo). Once engaged, the housing will rotate with the square drive
at a much higher rate than the maximum torque setting.
Use this feature when you want to run nuts on or off studs in a quick and
efficient manner.
When shifting between High Speed and Maximum Torque modes,
make sure the tool is stopped and fully engage in either the forward or
backward position. Failure to fully engage tool may affect the operation
of the tool and ultimately result in loss of control and/or damage to the
tool.