26
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Wake-up Timer Value in ERP
User can select a value in the range of [10] to [4095] seconds when ‘
WatchDog
Reset Timer Unit
’ set as [Sec]; or in the range of [1] to [4095] minutes when
‘
WatchDog Reset Timer Unit
’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (refer to
Page
10
, AT_MODE jumper for ATX Mode & AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
PS2 KB/MS Connect
Use this item to select PS2 connect primary device.
The optional settings are: [Keyboard First]; [Mouse First].
►
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN / SYSFAN1/ SYSFAN2 Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1/ SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN (/SYSFAN1/SYSFAN2) full speed temperature. Fan
will run at full speed when above this pre-set temperature.
CPUFAN / SYSFAN1/ SYSFAN2 Full-Speed Duty
Use this item to set CPUFAN (/SYSFAN1/SYSFAN2) full-speed duty. Fan will run
at full speed when above this pre-set duty.
CPUFAN / SYSFAN1/ SYSFAN2 Idle-Speed Temperature
Use this item to set CPUFAN (/SYSFAN1/SYSFAN2) idle speed temperature. Fan
will run at idle speed when below this pre-set temperature.
CPUFAN / SYSFAN1/ SYSFAN2 Idle-Speed Duty
Use this item to set CPUFAN (/SYSFAN1/SYSFAN2) idle speed duty. Fan will run
at idle speed when below this pre-set duty.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70
o
C/156
o
F]; [75
o
C/164
o
F]; [80
o
C/172
o
F];
[85
o
C/180
o
F]; [90
o
C/188
o
F].
►
Second Super IO Configuration
Second Super IO Configuration
►
Serial Port 7 Configuration/Serial Port 8 Configuration/Serial Port 9
