36
CLEANING THE JLR X
• Carefully wipe with a damp cloth and then dry with a dry cloth.
• Do not apply water directly to the JLR X. This can cause damage to the frame and electrical systems, which can result in
malfunctions that lead to personal injury.
BATTERY CARE
• Keep away from fire and excessive heat.
• Avoid intense physical impact and/or severe vibration.
• Protect from water or moisture.
• Do not disassemble.
• If there are any issues with the battery, contact the Jetson Care Team.
STORING THE JLR X
• Remove batteries before storing.
• Cover to protect against dust.
• Store indoors, in a dry place, and at a temperature at or above 50°F.
ADJUSTING THE CHAIN:
• The chain must be at the correct tightness.
• If too tight, the bicycle will be difficult to pedal.
• If too loose, the chain can come off the sprockets.
When the chain (C) is at the correct tightness, the crank can rotate freely and the chain can be pulled no more than one-
half inch (A) away from a straightedge (B), as shown.
To adjust the chain:
• Loosen the axle nuts of the rear wheel.
• Move the rear wheel forward or backward as necessary.
NOTE:
Make sure the rear wheel is centered under the bicycle frame.
• Hold the wheel in the desired position and tighten the axle nuts.
C
B
A
WARNING
:
Do not attempt chain repairs. If there is a problem with the chain, have a
bicycle service shop make any repairs.
Care & Maintenance
Summary of Contents for JLRX20-BLU
