Jets™ Charm Toilet
Tel. +47 70 03 91 00
www.jetsgroup.com
Product No. TO611PO
Issued 2013-10-28 Rev 3.0
Installation
Standards and Regulations
To install a Jets™ toilet it is first required that the room be prepared according to all local, state and federal standards and requirements. Industry
specific standards must also be met. Considerations that must be made include but are not limited to:
●
Appropriate proportioned drain pipes.
●
Water barriers/membrane.
Water Barrier
Note that in some countries, and as per the majority of standards and regulations, it is prohibited to mount toilets directly onto the wall if mounting
requires that the water barrier be compromised. Wall mounted toilets, in these circumstances, are therefore required to be mounted on internally
constructed walls within the water barrier. Check requirements according to local codes and standards before beginning any installation work.
General Disclaimer
Drawings provided in the following examples are for illustration purposes only. Product details may vary from your individual purchase.
Pre-Installation Considerations
It is recommended that items such as wall mounted release buttons, false boxed walls, drainage and piping etc. be installed/constructed, prior to
installation of the toilet.
Connection with Pressurized/Mains Water
To connect pressurized water (i.e. mains water) to the toilet, the water pipe must be installed. The connection required is a 1/2" BSP standard
connection. The water pressure must be a minimum of 1.8kp/2 bar and must not exceed 7 bar.
Installation Instructions
Toilet installation requires the following procedures to be carried out. For more specific technical details, refer to the component products individual
technical data sheet. For documentation that is delivered as a part of a manual or compiled technical document, the contents list contains a listing
of all enclosed documentation. For further information on any of the instructions supplied, any questions regarding installation and or the products,
please contact your local supplier or Jets™ Service Department.
Pre-Installation Wall Preparation
The toilet is a wall mounted model which can be installed in locations where
●
a service hatch at the rear is available (see Service Access).
●
the toilet bowl is to be removed from the wall for service (see Standard Installation).
For retrofit installations, contact your local approved supplier or Jets Vacuum AS for further information.
Service Access
Optional Service Access:
If service access from the rear is available, a cutout in the wall
surface will allow for maintenance to be carried out without removing
the toilet from the wall.
