Instructions manual: MULi6s Module
3. MULi6s Module sensor connection options:
1.
The MULi6s Module three-wire sensor cable with the JR connector can be connected directly to
the JETIBOX (connector labeled I -). Use the second JETIBOX input, which is marked
(+ -), to bring the supply voltage. This connection does not use wireless data transmission and the
measured values are displayed directly on the JETIBOX LCD. This connection does not allow the
generation of alarms because the siren is part of a transmitter module that is not connected in this
case. Alarms are only displayed on the LCD.
2.
Connect the 3-wire MULi6s Module sensor cable with the JR connector to the DUPLEX receiver
connector on the rear (marked Ext.). The MULi6s Module sensor is powered from the receiver.
To set the MULi6s Module sensor parameters, connect the JETIBOX to the transmitter module
and turn on the DUPLEX receiver and transmitter. You can also set this sensor using the Jeti DC /
DS transmitter in Menu / Model / Device Explorer.
Incorrect connection procedure:
The module connects to the disconnected receiver or the Jetibox and
the battery is connected.
6
