Instructions manual: MULi6s Module
4.2.
MULi6s Module MENU: MIN / MAX
- Press D (Down Arrow) to select the display of the
voltage extremes recorded during the measurement. Extreme recording is automatically deleted
according to the trigger settings in the "Settings" menu or can be deleted manually.
Reset Min / Max
- simultaneously pressing the R and L arrows (right and left) deletes the record of
the measured minimum and maximum parameters.
Weakest Cell
- Featuring the weakest cell for the entire flight - its voltage and cell number.
Total Volt MIN / MAX
- Shows the minimum and maximum total battery voltage measured over the
entire flight.
MAX Difference
- Displays the greatest voltage difference between the weakest and strongest cells
throughout the flight. In addition to the voltage, which of the two cells this difference affects, the first
number corresponds to the strongest cell.
Cell MIN MAX
- Displays the minimum and maximum voltages of the currently selected cell. Use R
and L to select the cell number that we want to view.
4.3.
MULi6s Module MENU MODE: SETTINGS
- Press D (down arrow) to enter the basic setting
of the sensor.
Min Max Trigger
- Set the voltage value for which the minimum and maximum will be reset when
the sensor is switched on for the first time.
4.4.
MULi6s Module MENU: ALARMS
- Press the D (Down Arrow) button to enter the individual
alarm settings. If a set parameter is exceeded, then the JETIBOX LCD in the main menu on the
second line will alternately display the original display with the corresponding alarm, while the
red LED will illuminate at the time of the alarm display. If the alarm is set to "Off", the alarm is
off. If multiple alarms occur at the same time, they are displayed on the second line of the
JETIBOX.
Total Voltage Alarm
- Low battery alarm setting. If the measured total battery voltage drops below
the set value, an alarm is activated.
Weakest Cell Alarm
- Set low-voltage signalling for the cell. If the measured voltage of any cell
falls below the set value, the alarm is activated.
Difference Alarm
- Alarm signalling for a large voltage difference between the strongest and the
weakest cells. If the measured voltage exceeds the set value, the alarm is activated.
4.5.
MULi6s Module MENU MODE: SERVICE -
Press the D (down arrow) key to enter the
firmware version display and restore the default sensor settings.
Factory Defaults
- Press R and L (right and left) simultaneously to upload the MULi6s Module
sensor default setting.
MULi6s Modul v. Xx.xx ID xxxxx : xxxxx
– Product name with firmware version and serial
number (ID).
8
