User´s manual: Intelligent switch ENLINK 2RS Plus
-5-
ATV High Limit
- the maximum output limit.
ATV Low Limit
– the minimum output limit.
Default Setting
- pushing buttons on the right and left will reset all values to the factory settings.
4.
Version with PPM Output Firmware
ENLINK 2RS Plus with the PPM software is primarily used to transfer the PPM signal. The PPM
signal brought to one of the ENLIK inputs is copied to the output. ENLINK 2RS Plus checks if there
is signal on Master. If there is, it is immediately, without delay, copied to the output. If a signal loss
occurs on the Master, the ENLINK switches to Slave and starts copying signal from the Slave in case
there is any on its input. As soon as the signal is restored, the ENLINK switches back to copying the
Master signal.
In the version with the
PPM
firmware, it is
not possible to set the ENLINK via JETIBOX terminal
.
ENLINK 2RS Plus is even able to copy some types of communication (such as UDI, EX Bus) up to
the speed of 125kbps. Therefore, it can be used even in cases when it is necessary to use longer wiring
that can cause deterioration of the communication quality. The ENLINK 2RS Plus therefore functions
as a repeating device, where you just plug in one of the ENLIK 2RS Plus inputs.
The ENLINK 2RS Plus copies the signal unidirectionally, therefore it cannot be used to transmit the
two-way communication.
