JETI model DUPLEX DC-24, Manual, Page: 139 / 168

computer radio control system EN
4. 4.
9.6.5 System Sound
This menu allows you to assign any available sound file to the system
events.
-Start-Up - associated file is played when the transmitter is turned
on.
-Receiver Bound - Assigned file is played after the receiver is turned
on and communication with the transmitter is established.
-Low TX Voltage - Optional file with a warning at low transmitter
voltage. You can also set an adjustable voltage level which says when
the alarm will be activated.
-Low Signal - An optional file with a warning at low signal level. The
file is played when the signal level of both antennas falls below a
number specified in the parameter
"Value" .
- Low Signal: Q – If the signal quality drops below the percent value,
the assigned audio file will be played.
-Signal Loss - T he associated file is played after signal from the
receiver is lost.
-Range Test - T he associated file is played repeatedly in the "Range
Test" mode.
-Autotrim Active - T he associated file is played repeatedly when the
Autotrim function is active.
- Inactivity alarm - You can assign an audio file and time interval for
inactivity warning. The alarm will be triggered repeatedly when
there are no buttons being used and the sticks are holding their last
positions for an extended period.
9.6.6 Sound Volume
Here you may select volumes for each part of the audio system
individually. You are also free to assign any proportional control
(stick or knob) for adjustment. The first row represents a master
volume for the transmitter. Other volumes are then derived relative
to this value.
•
Beep Volume – controls volume of beeping and trimming.
•
Vario Volume – intensity of vario tone signalising.
137