V1.5 ©2009 JetAir Technologies, LLC
- 10 -
10.
Tighten end bolt on Air Knife or JetBlast™ and lock into 15º position.
11.
Attach Flexible Hose with Hose Clamp to Air Knife or JetBlast™ Inlet. Run hose
to Blower or manifold, avoid tight bends and minimize hose length as much as
possible. Trim and attach to blower outlet with hose clamp. Note: hose
lengths longer than 10’ should be “hard” piped with SS Tube or PVC Pipe to
minimize line friction.
Air Knife or JetBlast™ JetLine™ Mounting Brackets:
End/End (used when inlet is in body of knife): p/n 20503
Ø1” Inlet/End:
p/n 20513
Ø1” Inlet/Ø1” Inlet (used for dual inlet knife): p/n 20514
Ø2” Inlet/End:
p/n 20523
Ø2” Inlet/Ø2” Inlet:
p/n 20524
Ø3” Inlet/End:
p/n 20533
Ø3” Inlet/Ø3” Inlet:
p/n 20534
Ø4” Inlet/End:
p/n 20543
Ø4” Inlet/Ø4” Inlet:
p/n 20544
To install Side Mounted Air Components in Permier™ or JetTunnel™:
1.
Insert
Vertical Bent Tube
into
JetSet™ Bracket
.
2.
Attach
End Bracket
to Vertical Bent Tube.
3.
Attach
AirKnife or JetBlast™ End Bolt
to End Bracket. Do not tighten end bolt
at this time.
4.
Position Air Knife or JetBlast™ by hand to identify position of second conveyor
mounting bracket. Raise or lower Vertical Bent Tube in Conveyor Mounting
Bracket as needed.
5.
Insert second
Vertical Bent Tube
and attach
Inlet Bracket
.
6.
Attach Air Knife or JetBlast™ by inserting its inlet through inlet bracket.
7.
Adjust Air Knife or JetBlast™ into operating position by adjusting inlet and end
brackets and conveyor brackets. Typically Air Knives work best when <1”
[25mm] from object to be blown-off and rotated on its axis 15º down. AirKnife
should blow-off product first at its highest location on the product.
Line Direction
