13
Extension Wings
Referring to Figure 8:
1. Attach an extension wing (A) to the table (B) on
the right side using three M10x20 hex cap
screws (C), three M10 lock washers (D), and
three M10 flat washers (E). Hand tighten only
at this time.
2. Repeat for the left side.
Rear Guide Rail
Referring to Figure 9:
Required Fastening Hardware:
A – 1 ea – Connecting Plate
C – 2 ea – Socket Head Cap Screws (1/4)
D – 2 ea – Flat Washers (1/4)
G – 4 ea – Socket Head Cap Screws (5/16x1)
H – 4 ea – Spacers
J – 2 – Flat Washers (5/16)
K – 2 – Hex Nuts (5/16)
L – 2 ea – Lock Washer (1/4)
Required Tools:
5mm Hex wrench
12mm wrench
1. Place the
connecting plate
(A) into the long
rear rail section
(B), lining up the mounting
holes. Insert a 1/4"
socket head cap screw
(C),
1/4" lock washer (L) and 1/4"
flat washer
(D)
through the rail; thread into the connecting
plate (A) and secure tightly using a 5mm Hex
wrench.
2. Join the short
rear rail section
(E) to the long
rear rail section and secure to the protruding
end of the connecting plate in the same
manner as described in step 1.
3. Insert two 5/16x1 socket head cap screws (G)
into the middle mounting holes of the
assembled rear rail. The screws should be
inserted through the side with the larger
opening.
4. Place
spacers
(H) on the protruding threaded
ends of the screws, then
partially secure
the
rail to the threaded mounting holes on the rear
of the table.
5. Insert two 5/16x1 socket head cap screws (G)
into the outer mounting holes of the rear rail.
Place
spacers
(H) on the ends of the screws,
then insert the screws through the mounting
holes of the
extension wings
, securing them
with 5/16
flat washers
(J) and 5/16
hex
nuts
(K).
Figure 8
Figure 9
6. Tighten firmly the two screws holding the rail to
the table. Do not tighten the screws holding the
rail to the extension wings at this time.
Summary of Contents for JWTS-10JF
Page 34: ...34 JWTS 10JF Exploded View...
Page 35: ...35...
Page 37: ...37 JETFENCE Exploded View...
Page 39: ...39 Wiring Diagram...