19
Belt and Belt Cover
1. Lower the saw blade completely. This makes it
easier to position the
v-belt
on the
arbor pulley
.
2. Position the
v-belt
(A, Fig. 24) on the arbor
pulley, lift up on the
motor assembly
, place the
v-belt on the
motor pulley
(B, Fig. 24), and
carefully lower the motor.
3. Place the M8x40
carriage bolt
(C, Fig. 24)
through the hole in the belt guard bracket.
Place
spacer
(D, Fig. 24) onto the carriage bolt.
4. Fasten the belt cover (B. Fig. 25) to the belt
guard bracket with an M8 flat washer and M8
wing nut (B, Fig. 25).
JETFENCE
Assembly
1. Place fence body (A, Fig. 26) into the fence
(B, Fig. 26).
2. Install four bolts (C, Fig. 26) with flat washers
and lock washers. Hand tighten.
3. Place the fence assembly on the guide rails,
slide to the nearest miter slot and clamp the
handle (D, Fig. 26) to lock.
4. Grasp the fence toward the rear of the saw and
move left or right until the fence lines up with
the miter slot.
5. Tighten the four bolts (C, Fig. 26).
6. Attach the cursor to the fence body with one
3/16"x1/4" pan head screw.
7. Lock the fence and take a test cut. Measure
the test cut and compare to the cursor reading.
Adjust the cursor, if necessary.
Adjustments
The JETFENCE has an adjustable rear slide (index
# 15 in the parts breakdown). The rear slide has
been adjusted at the factory and should not need
further adjustment. If, however, you find the space
between the fence and the table is not even front to
back (approximately 1/16”), make the following
adjustment:
1. Remove fence plug (Parts List
Item #14
).
2. Loosen two nuts (Parts List
Item #32
).
3. Adjust rear slide up or down.
4. Tighten two nuts (32) to lock rear slide in place.
The rear slide is properly adjusted when the space
between the fence and the table is approximately
1/16” and is same along the entire length of the
fence.
Figure 24
Figure 25
Figure 26
Summary of Contents for JWTS-10JF
Page 34: ...34 JWTS 10JF Exploded View...
Page 35: ...35...
Page 37: ...37 JETFENCE Exploded View...
Page 39: ...39 Wiring Diagram...