19
Preset settings
The precision miter gauge has preset settings at
the 45º left, 90º and 45º right positions. To select
one of these settings:
1. Release
the
lock handle
(B, Fig. 14).
2. Flip
the
plate stop
(D) up so it rests on the
miter bar
(C).
3. Adjust
the
body
(A) until the
stop screw
(G)
for the selected angle presses against the
plate stop
(D).
4. Tighten
the
lock handle
(B).
Note:
If any of the preset
settings
are not
accurately indicated on the scale:
1. Verify first that the miter gauge is properly
calibrated (see
Calibrating the miter gauge
above).
At each preset setting that
does not
correctly
indicate the setting:
2. Loosen
the
lock nut
(H, Fig. 14).
3. Adjust the
set screw
(G) until the correct
setting is indicated.
4. Tighten
the
lock nut
(H).
Operating Controls
Start/Stop
Referring to Figure 15:
The JWS-25X shaper is equipped with a
pushbutton control system and reversing switch.
The green
start
(A) and red
stop
(B) pushbuttons
are mounted in a control enclosure on the front
of the machine.
To start the machine
1. Unlock the spindle (see
Unlocking the
Spindle
on page 17).
Before starting the machine,
make sure that the spindle is unlocked.
Failure to comply can cause damage to the
machine.
2. Set the
forward/reverse switch
(C) as
required.
Do not operate the
forward/reverse switch while the motor is
running. Wait until the spindle comets to a
complete stop.
Figure 15
3. Press
the
green
start button
(A).
To stop the machine
4. Press the red
stop button
(B).
Note:
The red stop button also acts as an
overload reset button. If overload should trip,
reset by depressing the red stop button.
