10
Assembly
Figure 1
Fence Casting
1. Place
the
fence casting
(B) onto the table of
the
cabinet
(A).
2. Line up the threaded ends of the
lock
handles
(B
1
) with the
threaded mounting
holes
(A
1
) on the table. Tighten the
lock
handles
but allow sufficient slack to permit
the fence to be adjusted backward and
forward.
Fence
1. Place
a
plastic flat washer
(Q) on the
fence
lock knob
(P). Insert the threaded end of the
lock knob through the
slotted opening
(B
2
)
from the back of the
casting
(B). From the
front side, attach a
slide
(R) to the threaded
end of the
lock knob
(P) and tighten the
knob several turns.
2. Install
a
fence
(M) by engaging the track on
the rear of the fence with the
slide
(R).
3. Tighten
the
lock knob
(P), but allow enough
slack to permit the
fence
(M) to slide.
4. Repeat above steps to install the remaining
fence.
Featherboard
Loosen
lock handles
(N
1
) and slide the rail of the
featherboard
(N) so the squared edges of the
carriage bolt
underneath the
lock handles
(N
1
)
engage in the
track
along the top of the
fence
(M).
Cutter Guard
Place
flat washers
(J) on
two lock knobs
(H).
Insert lock knobs through the
slotted openings
on the
cutter guard
(C) and secure to the
threaded
mounting holes
(B
3
) on the
fence
casting
(B).
Handwheel Handle
Thread
handle
(F) onto the
handwheel
(F
1
) and
tighten with the
12mm wrench
(V) provided.
