Jet JWS-25CS, Owner'S Manual

Page: 7 / 24

7
Assembly
1. Attach table extension wing to the shaper
table using three hex cap bolts and three
washers.
2. Attach the rear door to the shaper cabinet
using two pins.
3. Attach the chrome handle to the raising and
lowering handwheel located on the front of
the machine.
4. Attach the plastic handle to the motor
bracket plate.
5. Place the dust chute (A, Fig. 1) on the table
and secure by threading two ratcheting
handles (B, Fig. 1) into the tabletop.
6. Secure the spindle guard assembly to the
dust chute using two knobs and two washers
(C, Fig. 1). Note: You should first attach
the wood piece to the two brackets with four
wood screws. Then attach the wood and
brackets to the plate guard using two screws
and washers.
7. Place the fence bracket assembly (A, Fig. 2)
on the table and secure by threading
ratcheting handle (B, Fig. 2) into dust chute.
8. Tighten hex cap bolt (C, Fig. 2) into the dust
chute using a 14mm wrench.
9. Attach the wooden fence (D, Fig. 2) to the
fence bracket assembly using two
countersink flat head screws (E, Fig. 2), two
large flat washer, two lock washers and two
hex nuts.
10. Feed the guide support (F, Fig. 2) into the
fence assembly and secure with a hex cap
screw (G, Fig. 2).
11. Slide the two brackets (H, Fig. 2) onto the
guide supports. Place the guide plates (I,
Fig. 2) between the brackets and the
supports. Tighten knob and hex cap bolt to
secure the guide plate in place. Note:
Repeat for opposite side fence