Jet JWS-25CS, Owner'S Manual

Page: 10 / 24

10
Fence Adjustments
1. Adjust fences by loosening ratcheting
handle (A, Fig. 7), turn knob (B, Fig. 7) to
adjust fence in or out, and tighten ratcheting
handle.
2. Adjust spindle guard height by loosening
two screws (C, Fig. 7), sliding guard up or
down to desired height, and then tightening
screws.
3. Hold down guides can be adjusted by
loosening knob (D, Fig. 7).
4. Hold in guides can be adjusted by loosening
hex cap screw (E, Fig. 7).
5. Guide supports can be adjusted by
loosening hex cap screw (F, Fig. 7).
Changing Cutters
Disconnect the machine from power source,
unplug!
Each size spindle is supplied with a safety lock
nut with left-hand threads located above the
spindle nut. To mount or change cutters, first
remove the safety lock nut. Remove the
spindle nut by placing one wrench on the
spindle nut and another wrench on the flats on
top of the spindle. Always replace the safety
lock nut before operating shaper.
Tool changing must be done with the utmost
care keeping in mind the following points.
1. Cutters, collars and spacers mounted on the
spindle shaft must have a perfect fit with no
room for movement or play between parts.
2. Holes and counterbores of cutters, collars
and spacers must be perfectly shaped
without rust, dings, nicks or other flaws.
3. Clean all cutters, collars and spacers before
installing them on the spindle.
4. Always mount the cutter as low as possible
on the spindle.
5. Make sure all parts on the spindle are
locked in position before starting the shaper.