Jet JRL-912, Operating Instructions And Parts Manual

Page: 14 / 28

14
Figure 8-1
6. The starting pin can be inserted into one of two
holes in the router plate (see Figure 7-3). It is
used as a support to help pivot the workpiece
into the bit when doing freehand work. See
Figure 8-2.
Always use starting pin
when doing freehand work. Use of the
starting pin in freehand work requires
removal of fence and bit guard – exercise
great caution. Keep hands away from
rotating bit. Failure to comply may cause
serious injury.
Figure 8-2
7. Do not perform “climb cuts” (feeding the work
with the bit rotation). Always feed work against
the bit rotation. See Figure 8-3.
8. For average work, where a portion of the
original edge of the work is not to be touched
by the cutter, both sub-fences are set in a
straight line as shown in Figure 8-3.
Figure 8-3
9. When the operation removes the entire edge
of the work, for example in jointing or making a
full bead, the shaped edge will not be
supported by the outfeed sub-fence when both
fences are in line. In this case, place a shim
behind the outfeed sub-fence that is equal
thickness to the depth of cut. To determine
size of shim, position a straight edge against
router bit and bring outfeed sub-fence against
it. See Figure 8-4.
Figure 8-4
9.0 User-maintenance
Lubricate the Router Lift chain with grease as
needed.
Use a brush, vacuum or compressed air to blow
out sawdust and debris from the dust collection box
and table area.
Periodically apply a light coat of paste wax to cast
iron table surface to inhibit rust.
9.1 Additional servicing
Any additional servicing should be performed by
authorized service personnel.