3
11.WEAR PROPER APPAREL. No loose clothing , gloves , neckties , rings ,
bracelets, or other jewelry to get caught in moving parts. Nonslip foot wear is
recommended . Wear protective hair covering to contain long hair.
12.ALWAYS WEAR EYE PROTECTION. Refer to ANSIZ87.1 Standard for
appropriate recommendations . Also use face or dust mask if cutting operation is
dusty.
13.SECURE WORK. Use clamps or a vise to hold work when practical. It’s safer
than using your hand and frees both hands to operate tool.
14.DON’T OVERREACH. Keep proper footing and balance at all times.
15.MAINTAIN TOOLS IN TOP CONDITION.
Keep tool sharp and clean for best and safest performance. Follow instructions
for lubricating and changing accessories.
16.DISCONNECT TOOLS before servicing and when changing accessories such
as blades,bitscutters,etc.
17.USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recommended accessories. The use of improper
accessories may cause hazards.
18.AVOID ACCIDENTAL STARTING. Make sure switch is in “OFF”postion
before plugging in power cord.
19.NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or
if the cutting tool is accidentally contacted.
20.CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to ensure that it will operate
properly and perform its intended function check for alignment of moving parts
binding of moving parts,breakage of parts mounting , and any other conditions
that may affect its operation.A guard or other part that is damaged should be
properly repaired or replaced.
21.DIRECTION OF FEED. Feed work into a blade or cutter against the
direction of rotation of the blade or cutter only.
22.NEVER LEAVE TOOL RUNNING UNATTENDED.TURN POWER OFF.
Don't leave tool until it comes to a complete stop.
23.DRUGS ALCOHOL, MEDICATION. Do not operate tool while under the
influence of drug,alcohol or any medication.
24.MAKE SURE TOOL IS DISCONNECTED FORM POWER SUPPLY while
motor is being mounted, connected or reconnected.
