7
body of the spring housing.) Reset lockscrew make sure point of screw mates
the flat on the housing journal.
(1)
Preparing for Drilling (see fig.2)(Except addition power feed system).
Turn of the knob make loose the taper body of worm gear and spring
base. Then we decide spindle stroke setting the positive depth stop gauge
for drilling blind hole or free state for pass hole.
(2)
Preparing for milling(see fig.2)(Except addition power feed system)
(a)
Adjust the positive depth stop gauge to highest point position.
(b)
Turn tight of the knob be use to taper friction force coupling the
worm gear and spring base. Then turning the handle wheel by micro
set the spindle of work piece machining height.
(c)
Lock the rack sleeve at the desired height with fixed bolt.
ADJUSTING TABLE SLACK AND COMPENSATE FOR WEAR(see fig.3)
(1)
Your machine is equipped with jib strip adjustment to compensate for wear
and excess slack on cross and longitudinal travel.
(2)
Clockwise rotation the job strip bolt with a big screw for excess slack
otherwise a little counter cloclwise if too tight.
(3)
Adjust the jib strip bolt until feel a slight drag when shifting the table.
CLAMPING TABLE BASE AND MACHINE BASE (See Fig.3)
(1)When milling longitudinal feed.It is advisable to lock the cross feed table
travel to insure the accuracy of your work. To do this , tighten the small leaf
screw located on the right side of the table base.
