10
Installing Cutterhead Guard
Orient guard (Fig. 8) in proper position and
insert post into hole in table. Tighten lock screw
(A, Fig. 8).
Installing Access Door
Install access door by placing bottom of panel
into access in stand and fastening by turning
latch (Fig. 9).
If the access door latch needs adjustment:
1. Remove the access door from the stand.
2. Loosen the hex lock nut (A, Fig. 9). Rotate
the latch a quarter turn clockwise to tighten
and counterclockwise to loosen.
3. Tighten the lock nut (A, Fig. 9).
4. Re-install the access door.
Installing Dust Chute
Attach the dust chute (Fig. 10) to the stand with
four screws and four flat washers, through the
pre-tapped holes in the stand.
Electrical Connections
Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.
Model JJ-8CS:
Remove the cover of the switch
box (A, Fig. 11) and mount the box to the right
side of the stand using the two screws provided.
Insert the motor leads through the hole in the
stand as shown, and insert a grommet (B, Fig.
11).
Consult the wiring diagram inside the switch box
cover. The diagram is also on page 30 of this
manual.
Figure 8
Figure 9
Figure 10
Figure 11
