11
10
PEAK HOLD MODE OPERATION
Red LED
Max. Set Torque or greater
Long Beep
(((((((( )))))))) ((((((( )))))))
Over Max. Target Value
Current Max. Value
(Peak Hold)
START
Apply Torque
Note:
1. If
appears, torque has been applied in excess of 110%
of maximum value. Recalibration is required.
2. Press
while display is flasing to record value. If
appears wrench memory is full and the next value cannot be
written in. Please refer to “Peak Hold Mode Recorded Value
Review” section to clear memory data. Skip this step if recording
of data is not required.
3. The green LED’s will light at 80%, 85%, 90%, 95%, and 97.5%
of set torque value to show progress.
4. The red LED’s will light at 100% of set torque value. Beeper tone
will be steady until handle is released. This is a stop signal.
5. Unit displays peak torque applied until reset or used again.
((…((… …))…)) ((…((… …)) …))
Short
Beeps
Green LED
Over 80% of Set Torque
Flashing
Apply Torque Over 5 N-m
Released
Max. Target Value
Over 80% of Max. Target Value
Recording
*Note 2
*Note 1
(System initial)
*Note 3
*Note 4
