10
9
TRACK MODE OPERATION
Long Beep
(((((((( )))))))) ((((((( )))))))
Note:
1. If
appears, torque has been applied in excess
of 110% of maximum value. Recalibration is required.
2. When using Track mode LCD will begin to show
changes after 5 Nm has been applied. If applied torque
is less than 5 Nm display will show no change.
3. The green LED’s will light at 80%, 85%, 90%, 95%, and
97.5% of set torque value to show progress.
4. The red LED’s will light at 100% of set torque value.
Beeper tone will be steady until handle is released. This
is a stop signal.
5. Unit displays 0 when handle is released.
Apply Torque Over 5 N-m
Current Torque Value
Current Torque Value
*Note 1
START
(System initial)
((…((… …))…)) ((…((… …)) …))
Short
Beeps
Red LED
Max. Set Torque or greater
Max. Target Value
Green LED
Over 80% of Set Torque
Over Max. Target Value
Over 80% of Max. Target Value
*Note 4
*Note 2
*Note 3
