11
Cutting of wedges
Curved cuts
Arc cuts
7. Setup and adjustments
General note:
Setup and adjustment work may only be carried out after the
machine is protected against accidental starting by pulling the
mains plug.
7.1 Changing the sawblade
The sawblade has to meet the technical specification.
Choose a suitable sawblade, according to the cutting operation
and according to the material to be cut.
For high rip cuts:
- use a wide sawblade (e.g. 15mm), coarse teethed.
For narrow curved cuts:
- use a narrow sawblade (e.g. 6mm).
Check sawblade for flaws (cracks, broken teeth, bending)
before installation. Do not use faulty sawblades.
The sawblade teeth must point in cutting direction (down)
Always wear suitable gloves when handling sawblades.
The sawblades may only be changed when the mains plug is
pulled!
Replacing the bandsaw blade
1.
Isolate the machine from the supply, pull the mains plug
2.
Open the top and bottom bandwheel doors by turning the
door locks (A, Fig 21) with a flat bladed screwdriver.
Fig 21
3.
Remove the Rip fence guide (B) from the front of the table
by releasing the 4 winged screws (C).
4.
Release the blade tension by turning the large knob (D).
