14
7.7 Table tilting
To tilt the table to a specific angle.
Ensure the table is clear of loose objects.
Loosen the winged nut (D, Fig 31) on the lower trunion, then
tilt the table to the angle required using the scale (E).
Fig 31
Retighten the winged nut.
Note:- When using the table at an angle always have the rip
fence on the lower side of the table to support the workpiece.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be carried
out after the machine is protected against accidental starting
by pulling the mains plug.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Clean the machine regularly.
NEVER USE WATER OR OTHER LIQUIDS TO CLEAN THE
MACHINE. USE A BRUSH.
Keep the ventilation slots of the motor clean to prevent it from
overheating.
Inspect the proper function of the dust extraction daily.
All protective and safety devices must be re-attached
immediately after completed cleaning, repair and maintenance
work.
Defective safety devices must be replaced immediately.
Inspect the correct blade tension regularly. Take away the
blade tension if the machine is not in use for a longer time
period.
Inspect the blade guide adjustment regularly.
Wheels:
The rubber tyre of the wheels must be cleaned regularly.
The upper wheel support must be lubricated regularly.
Drive:
The belt tension must be inspected regularly.
Table insert:
Replace a worn table insert.
The table insert may not project above table surface.
The table insert must be made out of cutable material (e.g.
wood, plastic, aluminium)
JET Stock number: JBS12-120
The table insert may not project above table surface.
Saw blades:
The servicing of saw blades should only be performed by a
trained person.
Only use sharp and properly set saw blades.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
11. Available accessories
Refer to the JET-Pricelist
for various saw blades.
Stock number 709209
Foldable roller stand.
