7
5.0
Setup and assembly
Read and understand all
instructions before attempting assembly. Band
Saw must be disconnected from power during
all assembly procedures. Failure to comply may
cause serious injury.
5.1
Shipping contents
See Figures 5-1 and 5-2.
1 Band saw (not shown)
2 Wheels
–
A
2
Adjustable foot with nuts and washer –
B
1
Vertical cutting plate –
C
1
Vertical cutting plate stand –
D
1
Open end wrench 12/14mm –
E
1
Work stop assembly –
F
1 Handle
–
G
1 Handwheel
–
H
1 Axle
–
I
1 Stand shelf –
J
2
Stand cross braces –
K
1
Stand front panel –
L
4
Stand legs (2 LH, 2 RH) –
M
1
Hardware package, includes:
19 Phillips hd screws, 1/4x5/8 –
HP1
6
Socket hd cap screws, 5/16x1-1/4 –
HP2
2
Cotter pins, 1/8x1 –
HP3
6
Flat washers, 5/8 –
HP4
20 Flat washers, 1/4 –
HP5
20 Hex nuts, 1/4 –
HP6
1
Flat head screw, 1/4 x 3/4 –
HP7
6
Flat washers, 5/16 –
HP8
6
Hex nuts, 5/16 –
HP10
Figure 5-1: Hardware package HVBS56V-HP
5.2
Tools required for assembly
Wrenches, 10mm, 12mm
Hex wrench, 4mm
#2 cross point screwdriver
Pliers
(Note: Ratchet wrench with sockets will speed
assembly.)
5.3
Unpacking and cleanup
1. Inspect all contents for shipping damage.
Compare contents of shipping carton with
contents list in this manual. Report any damage
or part shortages to your distributor.
2. Do not discard packing material until saw is
assembled and running properly.
3. Remove rust protectant from exposed surfaces,
such as bed, vise assembly, etc., with a clean
rag and cleaner/degreaser. Apply a light coat of
oil on these surfaces to inhibit rust.
Figure 5-2: contents
Summary of Contents for HVBS-56V
