Jet AB-1012W, Operating Instructions And Parts Manual

Page: 23 / 52

23
16.0 Control Panel
Figure 32
A – Main Power Switch – (Located on front side of control stand.)
B – Touch Screen – Lights up when Main Power Switch (A) is activated.
C – Emergency Stop – stops all machine functions; rotate button clockwise to release
and restart machine.
D – Electrical Power Indicator
E – Hydraulic Pump Start – When pressed, indicator will light. Press again to turn off.
F – Start Blade – Begins cutting operation.
G – Work Light – Button will light when on. Press again to turn off.
H – Coolant Flow – Button will light when coolant pump activates. Press again to turn off.
J – Auto/Manual Mode – Clockwise to auto mode; counterclockwise to manual mode.
K – Shuttle Vise Backward *– Retracts the shuttle/work piece.
L – Shuttle Vise Forward* – Advances the shuttle/work piece.
N – Bow Up – Raises the saw bow and stops machine operations without re-setting. (Work piece will remain
clamped.)
O – Bow Down – Lowers the saw bow.
P – Shuttle Vise Open* – Press and hold to adjust width. If bow is not at proper height clearance, each push of
button will open vise 5mm. If bow is at proper clearance height, vise will open one full length.
R – Shuttle Vise Close* – To approach or clamp the shuttle vise on the work piece.
S – Bench Vise Open* – Press and hold to adjust width. If bow is not at proper height clearance, each push of button
will open vise 5mm. If bow is at proper clearance height, vise will open one full length.
T – Bench Vise Close* – To approach or clamp the work piece.
U – Downfeed Pressure – The speed at which the bow lowers into the workpiece.
V – Blade Speed
* The saw bow will not move if any one of these clamping indicator lights is not illuminated.