Jet AB-1012W, Operating Instructions And Parts Manual

Page: 15 / 52

15
Pressure and Probe Arm limit switch.
1E. Low Speed . Touch to activate slow motion of
shuttle vise when in manual mode using the
Shuttle Vise Forward/Backward buttons.
1F. Blade Run Time . Touch to bring up screen:
“Blade running time set to zero? – Yes/No” ,
and select (Figure 18).
1G. Set Blade Speed. Touch to directly input blade
speed (surface feet per minute or meters per
minute).
1H. Shows blade speed.
1 I . Error Display. Malfunction notices with possible
remedies. When touched, you can slide the
arrows to show history of previous error
messages (Figure 19). See
Troubleshooting –
Touch Pad Screen Error Notices in this
manual for a list of possible error notices and
their solutions.
1J. System Parameter . When touched, requires
password to enter (Figure 20). The password
for this first level is 1234. NOTE: System
parameters have been set by the
manufacturer, and should not require
adjustment.
Only qualified personnel
should change system parameters.
1K. Machine execution message.
1L. Current date
1M. Current time
11.3 F2 – Operation
Refer to Figure 21.
Touch F2 button to display operation execution
window, shown in Figure 21.
2A. Work Task number. Touch to go to F3 screen
to select operation.
2B. Mode indicator.
2C . Length Setting : Shows the pre-set length of
the current operation.
2D. Quantity Setting : of the current work task.
2E . Feeding Length : Total length of material that
has been fed, including distances beyond a
single shuttle stroke.
2F . Finished Quantity : Number of cut pieces
completed.
2G . Count Trim Cut In/Out : Touch after auto cycle
has begun to include or exclude trim cut.
2H. Bow stop position: Set bow to stop in upper or
lower position, after cutting is completed in
manual mode.
Figure 18
Figure 19
Figure 20
F2-Operation
Figure 21