Jet 718200K, Operating Instructions And Parts Manual

Page: 12 / 32

12
Adjustments
90° Fence Adjustment
Note : whenever making an adjustment to
the fence, lift the fence up slightly after
releasing the lock handle to avoid
scratching the table.
1. Set infeed table to the same height as
the outfeed table.
2. Move the fence by releasing lock
handle (A, Fig. 14) and pushing the
fence assembly until it overlaps the
tables.
3. Adjust the fence to a 90
°
angle by
releasing lock handle (B, Fig. 14),
pulling up on handle (C, Fig. 14), and
re-tightening lock handle (B, Fig. 14).
4. Place a combination square on the
infeed table. (Fig. 15)
5. If fence is not square to table, release
lock handle (B, Fig. 14), loosen nut (D,
Fig. 14), and turn bolt (E, Fig. 14) until
fence is square to table.
6. Tighten nut (D, Fig. 14) to retain the
setting. Tighten lock handle (B, Fig.
14).
45° Fence Adjustment
Note : Whenever making an adjustment to
the fence, lift the fence up slightly after
releasing the lock handle to avoid
scratching the table.
1. Loosen lock handle (A, Fig. 16). Move
the stop plate (B, Fig. 16) out of the
way and position the fence at the 45
°
angle. Make sure the fence sits
against the stop bolt (C, Fig. 16).
2. Place a combination square (D, Fig.
16) on the fence and table to confirm a
45
°
setting.
3. To adjust, loosen lock nut (E, Fig. 16),
turn bolt (C, Fig. 16) until a 45
°
angle is
obtained, and tighten lock nut (E, Fig.
16). Tighten lock handle (A, Fig. 16).
Recommended Extension Cord Gauges (AWG)
Amps
Extension Cord Length in Feet *
25 50 75 100 150 200
< 5 16 16 16 14 12 12
5 to 8 16 16 14 12 10 NR
8 to 12 14 14 12 10 NR NR
12 to 15 12 12 10 10 NR NR
15 to 20 10 10 10 NR NR NR
21 to 30 10 NR NR NR NR NR
*based on limiting the line voltage drop to 5V at 150% of the rated
amperes.
NR: Not Recommended.
Figure 13
Figure 14
Figure 15