Jet 708457DXJ, Operating Instructions And Parts Manual

Page: 10 / 40

10
Figure 6-6
6.7 Installing Cutterhead Guard
1. Remove the screw from the guard post .
Refer to Figure 6-7:
2. Turn spring knob (B) approximately one and
one half revolutions counter-clockwise (as
viewed from the top) and hold.
3. Insert the guard post into hole in table.
Make sure that the spring inside the spring
knob (B) engages the slot in guard post.
4. Thread the screw (C) back into the guard
post .
5. Check for proper operation. The cutterhead
guard (A) must return fully to the fence when
released. If guard does not return fully, pull
guard, apply more tension to the
spring knob
(B) by turning it another half turn counter-
clockwise, and re-insert guard. If guard
closes too quickly and strikes fence too
hard, release some tension on the spring.
6. Insert screw (C) back into the guard post.
Figure 6-7
6.8 Installing Access Cover
Refer to Figure 6-8:
Install access cover (A) by placing bottom of
panel in the stand and fastening with four #5-40
x 3/8" pan head screws and four flat washers
(B).
Figure 6-8
6.9 Installing Dust Chute
Refer to Figure 6-8:
Attach the dust chute (C) to the base with four
1/4" x 1/2"
machine screws and four 1/4"
washers (D).