Jet 708457DXJ, Operating Instructions And Parts Manual

Page: 8 / 40

6.0 Assembly
6.1 Unpacking and Cleanup
1. Carefully finish removing all contents from
both shipping cartons. Compare contents of
the shipping cartons with the list of contents
above. Place parts on a protected surface.
2. Set packing material and shipping cartons to
the side. Do not discard until machine has
been set up and is running properly.
3. Clean all rust protected surfaces (bed,
fence, etc.) with kerosene or diesel oil. Do
not use gasoline, paint thinner, mineral
spirits, etc. These may damage painted
surfaces.
Cutterhead knives are
dangerously sharp! Use
extreme caution when cleaning.
4. Apply a thin layer of paste wax to the bright
surfaces of the fence and tables to prevent
rust.
6.2 Installing Bed to Stand
Refer to Figure 6-1:
1. Place bed assembly (A) on top of stand (B).
Be sure the identification label (C) on the
bed faces the same direction as the switch
(D) on the stand.
Figure 6-1
2. Line up two holes in the stand top (E) with
holes in the bed assembly by viewing
through the access door in rear side of the
stand.
3. Attach stand to bed assembly by using two
3/8" lock bolts and lock washers (Figure 6-
2). Hand-tighten only at this time.
Figure 6-2
4. Line up the third hole in the stand (F) with
the hole in the bed assembly by viewing
through the dust chute (G).
5. Install the third 3/8" lock bolt and lock
washer through the dust chute (G) to secure
the bed to the stand.
6. Tighten all three lock bolts with a 14mm
wrench.
6.3 Installing Pedestal Switch (JJ-
6HHDX)
Refer to Figure 6-3:
1. The switch may be installed in either high
position or low position to suit the operator.
Slide the connection plug through the
opening (A) and secure the pedestal switch
using two 5/16”x3” screws (C) and 5/16” flat
washers (B).
2. Connect the plug of the pedestal switch to
the motor plug inside the cabinet.
Figure 6-3