10
33
5
41
45
Pull indexing pin knob
out and turn
Figure
19
b.
c
.
Turn your gauge until the 45° lines up with the 0° and then rotate
the indexing pin knob (Part
#5),
releasing the indexing pin knob
back into
the engaged position
.
Refer to
Figure 1
6
and
Figure
1
7
for engaged and disengaged positions.
Once the indexing pin knob has
locked into the 45
degree detent
hole on the gauge, lock the
Handle (Part #10). You will now be
able to perform
your 45 degree
cuts.
Repeat the steps above to set the gauge into any of the pre-determined degrees on the gauge.
Loosen the Handle (Part #10).
a
.
1
5
Pull the Indexing Pin Knob (Part #5) out and away from the gauge and turn it to disengage. This
will now allow the gauge to rotate freely.
The e
xample used below is setting
the gauge to
45°. See
Figure
19
Figure
18
How to Adjust the Mite-R-Excel
II™
The Mite-R-Excel II™ is machined with pre-determined detents in the gauge for 0°,15°, 22.5°, 30°, and
45°. The pre-determined detents are laser marked with a diamond
on the gauge.
