Figure
9
Using the 3/32
"
Hex Key provided,
attach the hex key extension (Part #63)
to the Hex Key
Figure
9A
and
insert the hex key into each of the two holes next to the Fence Locating Pin Knob and
loosen the #10-32 x 3/16
"
Flat Point Set Screw
s
(Part #37).
See
Figure 9
Add a 3
"
block of wood in between the blade and flip stop (
See
Figure 8
). **
Note:
You can use any
size of wood you may have lying around your shop for this step, just be sure to set your flip stop to
the
appropriate
length **
Slide the fence extrusion either closer or further away from the blade
until the block of wood
touches the blade
.
T
he distance from
the Fence to blade should be roughly 1/
16
"
once the fence
is adjusted.
Once the fence is set, using the 3/32
"
Hex Key
and
the hex key extension
provided, tighten both
of the #10-32 x 3/16
"
Flat Point Set Screw (Part #37)
d.
e.
f.
g.
44
6 3
63
61
3
7
6 1
36
37
4 0
Figure
9A
10
Make sure the gauge is set in the 0 degree
position. See
Figure 1
0
a.
S
quaring the Fence to the Table
Figure 1
0
