Page | 9
Setting the Functions Continued
7. Setting the Buzzer. (see screen #8 on page 7)
Get to screen #8 with [d03]
showing with the 3 flashing on the display by following the instructions on pages 6&7.
The buzzer can be set as an indicator, an alarm or to enable or disable various
functions. The chart below shows what each digit controls;
2
nd
digit (tens place)
0=Buzzers Enabled / Reverse Count Enabled
1=Buzzers Enabled / Reverse Count Disabled
2=Buzzers Disabled / Reverse Count Enabled
3=Buzzers Disabled / Reverse Count Disabled
1
st
digit (ones place)
2=Clutch Signal Buzzer Disabled
3=Clutch Signal Buzzer Enabled
To set the Buzzers, press and release
F3
to increase the ones digit between 2 and 3.
Press and release
F2
to select the tens digit. Press and release
F3
to increase the tens
digit between 0 and 3. Press and hold
F1
for more than 2 seconds to save and exit.
8. Setting the Min/Max Alarm Buzzer. (see screen #9 on page 7)
Get to screen #9
with [U 3] showing with the 3 flashing on the display by following the instructions on
pages 6&7. The Min/Max Alarm Buzzer can be set as an alarm to alert when the
Trigger is released or the clutch activates and the motor revolutions are below the
Minimum number set or above the Maximum number set. The chart below shows what
each digit controls;
1
st
digit (ones place)
0=Neither the Minimum or the Maximum Alarms will sound
1=Only the Minimum Alarm will sound
2=Only the Maximum Alarm will sound
3=Both the Minimum and the Maximum Alarms will sound
To set the Buzzers, press and release
F3
to increase the ones digit between 0 and 3.
Press and hold
F1
for more than 2 seconds to save and exit.
9. Viewing the Cycle Totals. (see screen #10 on page 7)
Get to screen #10 with
[L00} showing on the display. These numbers indicate the total number of cycles where
the clutch activates whether the Count is On or OFF. Running the tool and releasing
the trigger before the clutch activates will not count as a cycle. These numbers can be
used to determine when to perform maintenance or to rotate the tool out of service.
The picture below shows how to read the numbers.
Note! These numbers can’t be
adjusted. Nothing will appear until after 99,999 Cycles and the maximum will be 9,999,999 Cycles.
