POWER 5500 5-Channel Amplifier
10
Testing
Before finishing the installation, perform the following tests to make sure the
wiring is correct and everything is operating properly.
5HFRQQHFW%DWWHU\
When wiring is complete, reconnect the battery negative terminal.
7HVW3RZHU:LULQJ
Turn on the receiver, but do not turn up the volume. The amplifier power light
should come on. If not, check the REM and +12V (B+) wires. Turn up the
receiver volume slightly. All speakers should operate. If not, check wiring
connections at amplifier and speakers.
7HVW6SHDNHU&RQQHFWLRQV
These tests make sure the speakers are connected properly. If speakers don’t
play at all, one (or both) speaker wires may be disconnected.
Remote Input Level Control
The Power 5500 comes equipped with a Remote Input Level Control. The
Remote Input Level Control allows the input level to be adjusted from an
alternate location. It can be mounted under-dash or in-dash. When the
amplifier is used to drive subwoofers and the low pass crossover is activated,
the Remote Input Level Control can be used as a « remote bass level control”.
This enables you to control the bass level independent from the rest of the
system. This is convenient for system tuning and/or when playing many
different types of music.
The Remote Input Level Control uses a 6-pin modular cable for connectivity.
Simply plug the 6-pin modular cable into the amplifier and then into the
Remote Input Level Control to activate the circuit.
Power
Min
Max
MIN
MAX
MIN
MAX
MIN
MAX
0dB
12dB
16Hz
160Hz
16Hz
60Hz
16Hz
160Hz
30Hz 160Hz
FULL
FULL
4CH
HPF
HPF
5CH
CH5/1
MODE
INPUT
CH5/2
CH4
CH3
CH2
CH3/4
CH5
CH1/2
CH1
REMOTE
REMOTE
LEVEL
LEVEL
LEVEL
BASS EQ
HPF
SUB SONIC
HPF
LPF
POWER
PROTECT
