E-8
ALARM OPERATION
The JCR-206 features a dual alarm clock.
Setting the alarms:
1. In standby mode, press and hold the
VOL - / ALARM 1
BUTTON
(#6), the hour of the alarm time will flash.
2. Tap
the TUNE - /
BUTTON (#3) or TUNE + /
BUTTON (#4) to set the hour
. Press and hold the button for
fast reverse/advance setting.
Make sure the correct AM or PM time is selected
when setting the hour.
Note:
The PM INDICATOR (#9) is located in the upper left part of the display. The
PM INDICATOR (#9) will light when the hour digits selected are for PM time. The
PM INDICATOR (#9) will be off when the hour digits selected are for AM time.
3. Tap the
VOL - / ALARM 1 BUTTON
(#6) to confirm the hour
setting, the minute digits will flash to prompt for input.
4. Tap
the TUNE - /
BUTTON (#3) or TUNE + /
BUTTON (#4) to set the
minute. Press and hold the button for
fast reverse/advance setting.
5. Tap the
VOL - / ALARM 1 BUTTON
(#6) to confirm the minute setting.
6. Tap the
VOL - / ALARM 1 BUTTON
(#6) repeatedly to select the wake up option
(ALARM 1 or Radio 1) and complete the ALARM 1 setting.
7. Setting the ALARM 2 time uses the same steps above, but using the
VOL + /
ALARM 2 BUTTON
(#7) in place of the
VOL - / ALARM 1 BUTTON
(#6).
Note: The unit will automatically save the settings and return to Standby mode if you
do not tap any button within 10 seconds.
Setting the “wake to” alarm source:
1. In Standby mode, tap the
VOL - / ALARM 1 BUTTON
(#6). The ALARM 1 time will
flash on the display and the current ALARM 1 status indicator will light on the left
side of the display.
2. Repeatedly tap the
VOL - / ALARM 1 BUTTON
(#6) to select the alarm source.
Wake to Alarm – ALARM 1 indicator lights.
Wake to Radio – RADIO 1 indicator lights.
Alarm OFF – All ALARM 1 indicators (ALARM 1/ RADIO 1) on the left side of the
display are OFF.
3. Setting ALARM 2 will follow the same steps as ALARM 1 above, but you will be
using the
VOL + / ALARM 2 BUTTON
(#7) and the ALARM 2 indicators will be on
the right side of the display.
Waking to Alarm - Turning the “wake to” Alarm ON:
A beeping Alarm will automatically turn on when the alarm time is reached. The
corresponding ALARM 1 or ALARM 2 indicator will flash.
The volume level of the alarm will start out low and gradually increase to maximum
volume.
Press the SNOOZE BUTTON (#5) to temporarily turn off the alarm, or
press the
STANDBY / SOURCE / ALARM OFF BUTTON (#8) to turn the alarm off.
If no buttons are pressed when the alarm is sounding, it will continue sounding for
60 minutes and then turn off automatically.
