E-6
INSTALLATION OPTIONS
ATTACHING THE STAND (See Illustration Below)
A. Turn the unit over as shown below, and align the top portion of the stand with the mounting
area located on the bottom of the main unit. Make sure the LOCKING TAB is facing out when
inserting the stand. Once in place, slide the stand forward towards the front of the unit until it
locks in place. A loud “Click” sound will be heard when it’s securely locked. Check that the
stand is locked firmly in place and does not come off.
B. Remove the stand by lifting the LOCKING TAB upward to unlock it from the main unit. At the
same time, pull the stand out and away from the main unit as shown below.
FOR WALL MOUNTING (STAND MUST BE REMOVED)
It’s important to be sure there are no electric, gas or water lines located behind the wall where you
are attaching the unit. We recommend having this speaker professionally installed. Use the
included wall mounting accessories and template to attach the sound bar to the wall.
1.
Use the supplied wall mounting instruction sheet to make marks on the wall for the plastic
anchors. Make sure the marks are level before drilling.
2.
Drill 1/4” holes on the marks.
3.
Insert the included plastic anchors into the holes until they are flush with the wall.
4. Screwing the 2 included flat head screws into the plastic anchor holes and tighten the screws.
5. When the screws are tightened, the screw heads should be about ¼” away from the mounting
wall. Line up the keyhole slots located on the back of the main unit with screws in the wall.
6. Hang the unit onto the screws.
