E-12
6. Press the /
Button
to set the minute and then press the
ALARM Button
again to
confirm, alarm wake up source will appear in display.
7. Press the /
Button
to select wake to CD, USB, Radio (Tu) or Beep (bu) and then press
the
ALARM Button
again to confirm, alarm volume level will be flashing.
Note:
Alarm volume level setting is not available in beeping alarm setting.
8. Press the
/
Button
to preset the wake up alarm volume level and then press the
ALARM Button
to finish alarm setup.
NOTE:
1.)
If “Wake to CD/USB” is selected but a CD/USB thumb drive is not inserted, the alarm will
default to the Beeping Alarm automatically when the alarm wake time is reached.
2.)
For ‘Wake to Radio”, the system will default to the last radio station listened to before switching
off.
ACTIVE/DE-ACTIVE ALARM FUNCTION
1. To active ALARM, tap the “
ALARM
”
Button
once, the alarm icon “
”
will shown on LCD
display.
2. To cancel ALARM function by tap again the “
ALARM
”
Button
until the alarm icon “
”
goes
off.
Wake to Radio, CD, USB or Beeping Alarm
When the alarm time is reached, the CD, USB, radio or beeping alarm will sound for the
time you set then shut off and reset itself for the following day.
To stop the alarm immediately after it sounds, press the
Button
on main unit or
Button
on remote control once. It resets itself for the following day.
To cancel the following day alarm, tap the
ALARM Button
once, ALARM icon“
”
goes off.
RADIO OPERATION
1. In Off (standby) mode, press the POWER/ STANDBY BUTTON on top of the main unit or
on the remote control to turn the unit ON.
2. Tap
the
FUNCTION Button
on main unit or
AM/FM Button
on the remote control repeatedly
to select AM or FM Radio mode. The “AM” or “FM” indicator will turn on to the left of the
channel frequency shown on the LCD Display to confirm what mode you are in.
3. To manually tune to a specific radio station, tap the
or
Button
on main unit or
TUNE+/TUNE- Buttons
on the remote control repeatedly. Use the manual tuning method to
tune in weaker stations that are bypassed during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold the
or
Button
on main unit or
TUNE+/TUNE- Buttons
on the remote control for 1-2 seconds until frequency
readout on the display begins to scan and then release the button. The tuner will stop
scanning when it receives the next broadcasting station of adequate signal strength.
5. Press the volume control
/–
Button
on main unit or
remote control to adjust the
volume control to the desired volume level.
FM & FM-Stereo reception
-
When listening to the FM radio, press the
FM ST./MONO Button
on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -
For best FM reception, the FM lead wire antenna located on the back of the unit
should be fully unwrapped and extended.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets skipped.
